KBK-活塞销用滚针和保持架组件
KZK-曲柄销用滚针和保持架组件
WJ-英制滚针和保持架组件
现货供应K182614轴承K182816滚针轴承K192313_K19*23*17
LWB精度 Precision
龙威滚针保持架组件公差如表1,当两个以上的轴承并联在同一轴上使用时,滚针必需属于同一分组值。保持架宽度公差Bc为-0.2/-0.55mm。
The dimensional tolerances of needle retainer are listed in Table 1. When bearings of more than two types are used in parallel on a same shaft, the needles must belong to the sub group with same value. The retainer width tolerance Bc is -0.2/-0.55mm.
表1滚针直径公差Table 1 needle diameter tolerance 单位 unit:um
精度等级Precision grade
|
滚针直径 Needle diameter tolerance
|
G2
|
0~-2 -2~-4 -4~-6
|
G3
|
0~-3 -3~-6 -6~-9
|
LWB 配合 Combination
龙威滚针保持架的径向间隙,取决于内外滚道及滚针的加工精度。表2为依据不同的使用条件推荐的配合。
The radical gap of needle retainer assembly depends on the machined precision of the inner and outer trays and the needles. The table 2 shows the combination recommend as per the different operational conditions.
LWB 根据G6加工外壳时推荐轴公差
Table2 the recommended shaft tolerance of the casing when machined as per G6
轴公称直径Nominal shaft
使用条件 Operational conditions
|
轴的推荐公差 Recommend shaft tolerance
|
≤80
|
>80
|
高转速
High speed,high precision
|
j5
|
h5
|
一般使用条件
General operational condition
|
h5
|
g5
|
高温或装配误差大
High temperature or great mounting tolerance
|
g6
|
f6
|
龙威检验标准要求当滚针直接在轴或外壳中运转时,为使滚针保持架组件达到全部负荷容,内外滚道面硬度必须为58-62HRC,粗糙度≤0.32μm,表面必须与滚动轴承滚道相同。
|